Buckling Analysis of a Square Plate

Let us consider a square plate with a side a and thickness h (see figure).

The thickness of plate h is much smaller than the length of its side a.
The plate is uniformly compressed in a transversal direction.
Consider the case when the loaded edges of plate are simply-supported; non-loaded edges are clamped.

Let us use the following data: plate side length a = 500 mm, thickness of plate h = 3 mm , applied distributed force P = 1 Pa.
Material characteristics assume default values: Young's modulus E = 2.1E+011 Pа, Poisson's ratio ν = 0.28.

Analytical solution for this problem is given by:

σcritical = K π2 D / a2 h ,

where E – Young’s modulus, D = E h3 / 12 (1-ν2) – cylindrical stiffness of plate, K – coefficient whose value depends on the type of  the supports of the plate edges (in this case K = 7.69).
Thus, σcritical = K π2 D / a2 h = 0.5188E+008 Pa.
After carrying out calculation with the help of AutoFEM, the following results are obtained:

Table 1. Parameters of finite element mesh

Table 2. Result "Critical load"*

 

 

*The results of numerical tests depend on the finite element mesh and may differ slightly from those given in the table.

 

Read more about AutoFEM Buckling Analysis

autofem.com

Return to contents